AlfaRadio AlfaSpid Rotator and Controller Instrukcja Użytkownika Pobierz pdf (Strona 10)



Page 10 of 20 file ~alfaspid/md-01/AlfaSpid_MD-01_Operation_15April2013_Master.doc April 15, 2013

11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8 sales@alfaradio.ca 780 466 5779 www.alfaradio.ca

Controller MD-01 configuration

When MD-01 Controller is in NORMAL mode you can use [S] button to

enter configuration mode.

The structure of the controller configuration mode is modular.

Select modules using buttons [Left] or [Right]. When you select a

module, you can use [S] button to enter in its parameters. Moving

between parameters is done with the [Left] or [Right] buttons. The

value of the parameter can change with the [Up] or [Down] buttons.

The [F] button is used for exiting the configuration mode. After

pushing the [F] button there is a question about writing current

configuration into memory. To confirm the changes, press the [Left]

button. To go back to previous configuration press the [Right]

button.

Motor configuration

The number before the ":" in the name of the template determines

which connector on the rear panel the motor must be connected:

1. AZIMUTH

2. ELEVATION

• TEMPLATE

The type of motors connected to the controller is pre-set by templates:

• 1:NC, 2:NC - no motors connected to the controller,

• 1:AZ, 2:NC - a motor is connected on the rear panel of controller on

connector AZIMUTH. Motor rotates only in azimuth,

• 1:NC, 2:EL - a motor is connected on the rear panel of controller on

connector ELEVATION. Motor rotates only in elevation,

• 1:AZ, 2:EL - there are two motors connected to the controller. Motor

1 (connector AZIMUTH) rotates in azimuth, and Motor 2 (connector

ELEVATION) rotates in elevation,

• 1:AZ, 2:AZ - there are two motors connected to the controller, which

is rotated in azimuth only.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Brak uwag

AlfaRadio AlfaSpid Rotator and Controller Instrukcja Użytkownika Strona 10